Aircraft control wire rope assemblies. Dimensions and end-fitting combinations1 Scope This International Standard specifies the possible combinations and lengths of preformed flexible steel wire ropes for aircraft controls equipped with two end fittings swaged on each end of the cable and the corresponding designations.

Site inspectors

service providers

It is at the court’s discretion whether the evidence is deemed admissible

Determination of length

Note 1: It is recommended that Part 1 of BS 4479 be read in conjunction with this Part

This section of IEC 287‑1 provides a method for calculating the eddy current losses in the metallic sheaths of single-core cables arranged as a three-phase double circuit in flat formation

duplicate inspections and restrictions that existed because of the lack of a definitive international standards

This PAS is a full revision of the 2008 version which it replaces

The standard colour is black

fault exclusion

Protection against mechanical hazards of ME equipment and me systems

backscattering