Continuous Flight Auger - 95MM Hole - CutDigga Continuous Flight Auger (CFA) 95MM Hole Cut The 95mm Hole Cut uses 80mm CFA's and an 95mm pilot. The 80mm CFA uses 1 1 8" Hex Joiners 80mm CFA's are available in 3 lengths: 1200mm 1500mm 1800mm Please Note: One (1) Joiner and Two (2) D Clips are required for each auger purchased. PILOT, JOINERS and D CLIPS need to be purchased separately. Joiners are available in Standard and High Tensile (HT). HT joiners are recommended for drive units over

it allows for superior visibility and access in confined spaces without sacrificing impact energy

Hyundai Excavator Models

5 tonnes and backhoes

The Digga PDH7 Earth Drill with HALO has a 75mm square hub and is suitable for mini excavators up to 7

this attachment easily locks onto your skid steer with no worries

Digga 750mm MFT RC10 Auger with pin and clip

Nominal Torque: 22142 Nm

Why are these recommended for Posi-Tracks

Increased Productivity: The wide gripping range allows you to handle various pipe sizes with a single tool

The Digga PD7 Earth Drill has a 75mm square hub and is suitable for excavators up to 7

Effortless Lifting: This single-phase powered vacuum lifter eliminates the need for manual lifting

Rock Breaker Grease