Hydraulic fluid power. Flush-face type, quick-action couplings for use at pressures of 20 MPa (200 bar) to 31,5 MPa (315 bar). Specifications

the recommended content of an engineering report covering the mechanical simulations is presented

movable & portable equipment) and four environmental classes

BS 1710 supports the legal requirement for those who install and use plumbing systems to prevent cross-contamination

rigid and semi-rigid thermoplastics sheets

Note 1: A combustible gas is a gas or any fuel that is in gaseous state at a temperature of 15 °C at a pressure of 1 bar

291 | ISO/IEC 9646-2

This part of ISO 11783 describes the messages required by tractors and self-propelled implements

[8] cause consequence diagrams[10] and LOPA

BS EN 1811 provides a measure of the amount of nickel release from an article immersed for one week in artificial sweat

The term “turbomolecular pump” used in BS ISO 27892 is generic and includes molecular drag pumps and pumps which contain both technologies on the same shaft

b) the hardness of the material measured on castings or on a cast-on knob

The standard therefore is unlikely to meet the requirements of the various specifying authorities for more comprehensive protection