Arducam CSI to HDMI Cable Extension Module with 15pin 80mm FPC Cable (Pack of 2)Arducam CSI to HDMI Cable Extension Module with 15pin 80mm FPC Cable (Pack of 2) The CSI HDMI adapter board is designed for V1 and V2 Raspberry pi camera board to extend the camera over the long cables while keeping the high speed CSI signals away from noise and interference. By using a high speed HDMI cable, the camera can run over 10 meters, that high extend the usage of the Raspberry Pi cameras. In addition, to extend the camera signal, the adapter

Datasheet (P1 Particle Module)

On-board PIC18FJ is preprogrammed with fast USB HID bootloader

39 grams (

which it means that you can have up to 2

You can easily solder these onto the Proto Shield so you can use them with your OpenMV Cam on-the-go

supports standard MQTT protocol IOT service such as Microsoft Azure IOT

it provides high-speed network access for cameras

• Pick and placeable component

which connect the desired reference resistor to the measuring circuit

mikromedia for STM32 M3 is fully supported by mikroC

a 32-bit PIC32MZ microcontroller

The F-Option design modification provides Maxbotix weather resistant sensors with extra protection against corrosive chemical environments