Shrink chuck 4,5° HSK 50 - 10 - 85Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Toolholders suitable for induction-

- Rustproof

Improves chip evacuation and decreases the risk for chip jamming

With fi ne adjustment carriage to feed the slider finely

- Integrated pull-down mechanism

5V AA Batteries * 3 ( Do not use low self-discharge battery )

Collets sealed for high pressure cooling 120 bar

Tensile strength in the core of min

20mm for over 500mm/20" range

Ratchet stop

Rotary holder for clamp holders with coolant supply directly to the cutting edge and for ISO clamp holders with claw clamping for optimum cooling of the cutting edge

Suitable for: