Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with polygonal taper interface with flange contact surface1 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with polygonal taper interface (PSC) with flange contact surface. The relationship between symbols in this part of ISO 10649 and the ISO 13399 series is given for information in Annex A.

The DTM is integrated into engineering tools via the FDT interfaces are defined in this specification

Quality control and regulatory authorities

but the marking is not required if Uimp equal to 4 kV

dimensional stability

The main aim of BS 3416 is to provide best industry requirements for bitumen-based coatings to ensure they offer adequate corrosion protection and waterproofing and at the same time do not pose as a concern for public health

This Technical Specification is not intended to supersede standards that cover specific products and industrial situations

The amendment adds requirements for legacy software which will help manufacturers demonstrate compliance with the relevant European Directives

BS EN 62562 is an international standard that focuses on the techniques to measure the complex permittivity of low-loss dielectric plates

which includes ambient temperature

The guidance deals with issues ranging from risk assessment through safeguarding to maintenance and safe working practices

or system quality scores

It also includes the terms and definitions given in BS EN ISO 14698-1 and BS EN ISO 14698-2